Temperature Controllers www.tempco.com | (800) 323-6859 | email:
[email protected] 13-31 Part Signal Number Input Out 1 Out 2 TEC51001 tc relay none TEC51002 tc relay relay TEC51005 tc SSR-1A none TEC51006 tc SSR-1A relay Power Input Standard: (TEC-410) 90-250 VAC, 47-63 Hz, 10 VA, 5W maximum (TEC-910) 90-264 VAC, 47-63 Hz, 10 VA, 5W maximum Optional: 11-26 VAC / VDC, 10 VA, 5W maximum Signal Input Resolution: 18 bits Sampling Rate: 5 samples / second Accuracy: ±.24% of span typical Maximum Rating: -2 VDC minimum, 12 VDC maximum (1 minute for mA input) Temperature Effect: ±1.5 μV / °C for all inputs except mA input ±3.0 μV / °C for mA input Sensor Lead Resistance Effect: T/C: 0.2μV/ohm Burn-out Current: 200nA Common Mode Rejection Ratio (CMRR): 120 dB Normal Mode Rejection Ratio (NMRR): 55 dB Sensor Break Detection: Sensor open for TC inputs Sensor Break Response Time: Within 4 seconds for TC and mV inputs; 0.1 second for 4-20 mA and 1-5 V inputs Output 1 / Output 2 Relay Rating: 240 VAC, 2 Amp Solid State Relay (Triac) Output Rating: 1A / 240 VAC Inrush Current: 20A for 1 cycle Min. Load Current: 50 mA rms Max. Off-state Leakage: 3 mA rms Max. On-state Voltage: 1.5 VAC rms Insulation Resistance: 1000 Megohms minimum at 500 VDC Dielectric Strength: 2500 VAC for 1 minute VDC Voltage Supply (Output 2 only) 20 VDC, ±0.5V, at 25 mA 12 VDC, ±0.3V, at 40 mA 5 VDC, ±0.15V, at 80 mA Event Input (standard TEC-410, optional TEC-910) Resolution: 18 bits Logic Low: -10 VDC minimum, 0.8 VDC maximum Logic High: 2 VDC minimum, 10 VDC maximum Functions: Remote reset, remote lockout Limit Control Modes available: High Limit, Low Limit and High/Low Limit Data Communications Interface: RS-485 (up to 247 units), RS-232, TEC-410 only Protocol: Modbus Protocol – RTU mode Address: 1-247 Baud Rate: 0.3 - 38.4 Kbits/sec Data Bits: 8 bits Parity Bit: None, Even or Odd Stop Bit: 1 or 2 bits Communication Buffer: 50 bytes User lnterface Single 4-digit LED Displays: 0.4" / 10 mm Keypad: 4 keys Programming Port: For automatic setup, calibration and testing Environmental and Physical Operating Temperature: 14 to 122°F (-10 to 50°C) Humidity: 0 to 90% RH, non-condensing Dielectric Strength: 2000 VAC, 50/60 Hz for 1 minute Dimensions: TEC-410: 3-3/4 × 3-3/4 × 2-9/16" (96 × 96 × 65 mm) H×W×D Depth behind panel: 2" (53 mm) Panel Cutout: 3-21/32" × 3-21/32" (93 × 93 mm) H×W Weight: 0.55 lb. (250 grams) TEC-910: 1-7/8 × 1-7/8 × 3-3/4" (48 × 48 × 94 mm) H×W×D Depth behind panel: 3-3/8" (86 mm) Panel Cutout: 1-25/32" × 1-25/32" (45 × 45 mm) H×W Weight: 0.33 lb. (150 grams) Approval Standards Safety: FM Class 3545 (OCT. 1998) EN61010-1 (IEC1010-1) TEC-410: UL61010C-1 TEC-910: UL873 Protective Class: IP30 front panel, indoor use, IP20 housing and terminals (with protective cover) EMC: EN61326 TEC-910 Stock and Common Part Numbers (Power Input: 90-264 VAC) Part Signal Prog. Number Input Out 1 I/O TEC16001 tc relay event input TEC16003 tc SSR-1A event input TEC16004 tc relay none TEC16006 tc SSR-1A none TEC-910 1/16 DIN Rear Terminal Connections TEC-410 Stock and Common Part Numbers (Power Input: 90-250 VAC) TEC-410 1/4 DIN Rear Terminal Connections NOTE: See page 13-46 for features common to TEC digital microprocessor-based temperature controls and the complete Table of Input Range and Accuracy.
Tempco Electric Heater Product Catalog
| Title Name |
Pages |
Delete |
Url |
| Empty |
Ai generated response may be inaccurate.
Search Text Block
Page #page_num
#doc_title
Hi $receivername|$receiveremail,
$sendername|$senderemail wrote these comments for you:
$message
$sendername|$senderemail would like for you to view the following digital edition.
Please click on the page below to be directed to the digital edition:
$thumbnail$pagenum
$link$pagenum
