Temperature Controllers www.tempco.com | (800) 323-6859 | email: [email protected] 13-13 Power Input Standard: 90-250 VAC, 47-63 Hz, 12VA, 6W maximum Optional: 11-40 VDC / 20-8 VAC, 47-63 Hz, 12VA, 6W maximum Signal Input Resolution: 18 Bits Sampling Rate: 5 Times / Second (200msec) Maximum Rating: -2VDC minimum, 12VDC maximum Sensor Break Detection: Sensor open for thermocouple and RTD inputs, sensor short for RTD input, below 1mA for 4-20mA input, below 0.25V for 1-5V input, not available for other inputs Sensor break responding time: Within 4 seconds for thermocouple and RTD inputs, 0.1 second for 4-20mA and 1-5V inputs Remote Set Point Input Type: Linear current, Linear voltage Range: -3-27mA, -1.3-11.5V Accuracy: ±0.05 % Input Impedance: Current: 2.5Ω, Voltage:1.5MΩ Resolution: 18 bits Sampling Rate: 1.66 times/second Maximum Rating: 280mA maximum for current input, 12VDC maximum for voltage input Temperature Effect: ±1.5μV / °C for voltage input, ±3.0μV / °C for current input Sensor Break Detection: Below 1mA for 4-20mA input, below 0.25V for 1-5V input, not available for other inputs Event Input Number of Event Inputs: 2 Logic Low: -10V minimum, 0.8V maximum Logic High: 2V minimum, 10V maximum CT Input CT type: TEC99998 Accuracy: ±2% of full scale reading, ± 1 digit maximum Input Impedance: 294Ω Measurement Range: 0-50A AC Output of CT: 0-5V DC CT Mounting: Wall (Screw) mount Sampling Rate: 1 time/second Output 1 /Output 2 Type: Relay, pulsed voltage, linear voltage and linear current Relay Rating: 2A, 240V AC, 200000 life cycles for resistive load Pulsed Voltage: Source voltage 5V, Current limiting resistance 66Ω Linear Output Resolution: 15 Bits Isolation Breakdown Voltage: 1000 V AC Load Capacity of Linear Output: Linear current: 500Ω maximum, Linear voltage: 10KΩ minimum Alarm Relay Type: Form A Maximum Rating: 2A, 240VAC, 200000 life cycles for resistive load Alarm Functions: Dwell timer, Deviation low, Deviation high, Deviation band low, Deviation band high, Process high, Process low Alarm Mode: Latching, Hold, Normal, Latching/Hold Dwell Timer: 0.1-4553.6 minutes Data Communications Interface: RS-485 Protocol: Modbus RTU Address: 1-247 Baud Rate: 2.8 - 115.2 Kbits/sec Parity Bit: None, Even or Odd Stop Bit: 1 or 2 Bits Data Length: 7 or 8 Bits Communication Buffer: 160 bytes Analog Retransmission Output Signal: 4-20 mA, 0-20 mA, 0-10V Resolution: 15 Bits Accuracy: ±0.05% of span ± 0.0025% / °C Load Resistance: 0-500Ω for current output, 10KΩ minimum for voltage output Isolation Breakdown: 1000VAC minimum Integral Linearity Error: ±0.005% of span Linear Output Ranges: 0-22.2mA (0-20mA / 4-20mA), 0-5.55V (0-5V, 1-5V), 0-11.1V (0-10V) User Interface Keypad: 4 Keys Display Type: 4 digit LCD display No. of Display: 3 Upper Display Size: 0.58" (15mm) Lower Display Size: 0.32" (8.3mm) Programming Port Interface: Micro USB PC Communication Function: Automatic Setup, Calibration and Firmware Upgrade Control Mode Output 1: Reverse (Heating) or Direct (Cooling) Action Output 2: PID cooling control, Cooling P band 50~300% of PB, Dead band -36.0 ~ 36.0 % of PB ON-OFF: 0.1-90.0 (°F) hysteresis control (P band = 0) P or PD: 0-100.0 % offset adjustment PID: Fuzzy logic modified Proportional band 0.1 ~ 900.0°F, Integral time 0–3600 seconds, Derivative time 0-360.0 seconds Cycle Time: 0.1-90.0 seconds Manual Control: Heat (MV1) and Cool (MV2) Failure Mode: Auto transfer to manual mode while sensor break or A-D Converter damage Ramping Control: 0 to 900.0°F / Minute or 0 to 900.0°F / Hour Ramp Rate Profiler Availability: Option No. of Segments / Program: 4 / 8 / 16 Environmental and Physical Specifications Operating Temperature: -10°C to 50°C Storage Temperature: -40°C to 60°C Humidity: 0 to 90 % RH (Non-Condensing) Insulation Resistance: 20MΩ minimum (@500V DC) Dielectric Strength: 2000V AC, 50/60 Hz for 1 Minute Vibration Resistance: 10 to 55 Hz, 10m/s2 for 2 Hours Shock Resistance: 200 m / s2 (20g) Moldings: Flame retardant polycarbonate Mounting: Panel Dimensions W × H × D: 2-27/32 × 2-27/32 × 2-3/8" (72 × 72 × 59 mm) Depth Behind Panel: 2" (50 mm) Cut Out Dimensions: 2-11/16 × 2-11/16" (68 × 68 mm) Weight: .7 oz (190 g) IP50 for the front panel, IP20 for rear terminals and housing. All indoor use. Rear Terminal Connections + + + + + + + + + EI2 mA A B V B V Remote SP CT1 CT2 V PTA TC+ PTB mA+ TC PTB mA V L N 90-250VAC 47-63Hz 12VA OP1 OP2 or AL1 AL3 AL2 EI1 AL4 V mA TXB RS-485 TXA NO C Retrans. I 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 25 24 23 22 21 20 19 26 27 28 29 30
